Installation precautions for Wall Mounted Ceramic Fan Heater

I. Key preparations before installation
Before installing a wall-mounted ceramic fan heater, it is necessary to confirm the wall type. Load-bearing walls (such as reinforced concrete walls or solid brick walls) should be preferred, and lightweight partition walls or gypsum board walls should be avoided to ensure that the wall's load-bearing capacity is greater than 3 times the weight of the equipment. Prepare tools such as electric drills, levels, expansion screws, screwdrivers, and check whether the fan heater package comes with special brackets and installation accessories. The installation height is usually recommended to be 1.5-2 meters from the ground, which can ensure that the hot air is evenly diffused and prevent children from touching it. The installation should be kept away from water sources (such as the shower area in the bathroom, keep a distance of more than 1 meter), flammable materials, and avoid air-conditioning outlets or radiators to prevent thermal efficiency from being disturbed.

II. Detailed explanation of installation steps
Use a level to mark the bracket hole position on the wall to ensure left-right symmetry and small horizontal error. The drilling depth must match the expansion tube, and tighten the screws after the expansion tube is embedded. Some models need to be accurately punched according to the "two screw spacing" marked in the manual to avoid the body tilting after installation.
Align the heater hook with the bracket slot and gently push it to the locked position to ensure that the body is stable and does not shake. The power cord needs to be grounded independently to avoid sharing the line with high-power electrical appliances. After powering on, start the device and test whether the switching of each gear is normal; check the sensitivity of the temperature control knob and observe whether the device automatically starts and stops at the preset temperature.

III. Precautions
In humid areas, it is necessary to use additional waterproof rubber rings to seal the screw holes and ensure that the socket waterproof box cover is closed.
If installed in a high dust environment, it is recommended to clean the air inlet filter every month to prevent dust accumulation from blocking and affecting the heat dissipation efficiency.
Frequently wipe the surface of the ceramic heating element of the air outlet with a soft cloth to avoid oil adhesion and affect heat conduction, clean the dust on the internal fan blades, and keep the airflow unobstructed.